Special lubricating grease with light coloured solid lubricants for slow, oscillating movements
Kluberlub BEM 41-122 is based on a mixture of mineral oil and synthetic hydrocarbon oil thickened with a special lithium soap and light coloured solid lubricants.
The special structure of Kluberlub BEM 41-122 combines with the friction surface to form wear-resistant tribo-layers. Such tribo-layers reduce wear and prevent tribocorrosion, thus increasing the component's service life. In addition the special additives contained in Kluberlub BEM 41-122 improve the general oxidation stability and corrosion protection of the lubricant.
Benefits for your application
for pivoting bearings, rolling and plain bearings
for high surface pressure
for slow oscillating movements
long-term lubrication due to formation of tribolayers
Heavy-duty grease for highly-loaded rolling bearings operating at low speeds
Kluberlub BE 41-1501 is designed to meet the requirements of rolling bearings subject to extreme conditions.
FAG FE 8 tests have confirmed the effectiveness of Kluberlub BE 41-1501 under these conditions and it is approved by various bearing manufacturers, e.g. FAG, to be used for applications in low-speed rolling bearings subject to very high loads and shocks, for example in roller presses and bowl mill crushers.
High-temperature grease for slow-running bearings
Klubersynth BH 72-422 is a synthetic high-temperature grease containing ester as well as perfluorinated polyether (PFPE) oils, and a PTFE thickener.
This grease shows good oil retention at high temperature and is thermally stable, which enables Klubersynth BH 72-422 to extend your relubrication intervals at operating temperatures above 160°C up to 220°C.
High-temperature long-term greases
Klubertemp HM greases are long-term lubricating greases based on perfluoropolyether oil and PTFE which has been specifically designed for high-temperature lubrication. Owing to the base oil viscosity and the high load-carrying capacity, Klubertemp HM greases are particularly suitable for the initial and relubrication of medium-speed rolling bearings subject to high temperatures and loads.
Graphite based operational lubricant for open gear drives
Because of its unique chemical composition based on an aluminium soap thickener, the GRAFLOSCON C-SG 0 ULTRA provide good adhesion that protects the tooth flank even at extreme loads.The life of the gear is enhanced by the presence of fine graphite particles that form a protective layer and prevent damage.
The vibrations and temperature difference across the tooth flank are reduced. The gears are also protected against corrosion due to the special additives.
Synthetic heavy-duty grease for long-term lubrication
Klubersynth HBE 94-401 is a lubricating grease based on high-quality synthetic base oil and a special calcium complex soap thickener. This combination enables the formation of a lubricating film with high resistance to mechanical loads providing excellent wear protection. Moreover, Klubersynth HBE 94-401 is resistant to water and has a good sealing effect due to the special thickener component used.
Light-coloured special lubricant for open drives
Klubersynth AG 14-61 has been especially designed for girth gear/pinion drives and plain bearings in wind turbines. The lubricant is resistant to high loads and provides very good corrosion protection properties. It can be used in a wide service temperature range and is therefore pumpable at temperatures as low as minus 30°C. The grease offers good pressure and wear resistance and is free from inorganic solid lubricants like MoS2 and graphite. Due to its good compatibility with commercial sealing materials Klubersynth AG 14-61 is suitable for wide ranging applications.
