High-temperature long-term greases
Klubertemp HM greases are long-term lubricating greases based on perfluoropolyether oil and PTFE which has been specifically designed for high-temperature lubrication. Owing to the base oil viscosity and the high load-carrying capacity, Klubertemp HM greases are particularly suitable for the initial and relubrication of medium-speed rolling bearings subject to high temperatures and loads.

Synthetic lubricating grease for valves, fittings with EPDM seals
PARALIQ GTE 703 is a special lubricating grease based on silicone oil and PTFE.
It is registered as NSF H1 and complies with FDA 21 CFR § 178.3570. It was especially developed for the incidental contact with products and packaging materials in the food-processing, cosmetics, pharmaceutical.
It may also be used for very low-load rolling bearings used in the beverage industry where an EPDM-compatible H1 lubricant is required.

High-temperature grease for slow-running bearings
Klubersynth BH 72-422 is a synthetic high-temperature grease containing ester as well as perfluorinated polyether (PFPE) oils, and a PTFE thickener.
 
This grease shows good oil retention at high temperature and is thermally stable, which enables Klubersynth BH 72-422 to extend your relubrication intervals at operating temperatures above 160°C up to 220°C.

Special lubricating greases for boundary friction conditions and tribo-corrosion
MICROLUBE GL 261, GL 262 greases are special lubricating greases on a mineral oil base, special lithium soap and the MICROLUBE additive package. Running-in wear is reduced to a minimum. In addition, the MICROLUBE additive package provides protection in the boundary friction regime, thus preventing tribo-corrosion. These greases have the capacity to absorb high pressures, and they have good anti-corrosion properties.

High-temperature lubricating grease
Kluberlub PHB 71-461 is a special high-temperature lubricating grease based on mineral oil and polyurea. It is suitable for a wide service temperature range and can be used up to 180°C under continuous relubrication conditions. Kluberlub PHB 71-461 may be applied via centralized lubrication equipment.
Kluberlub PHB 71-461 incorporates special EP additives ensuring good wear protection under high load conditions.

Multi-purpose greases for rolling and plain bearings
CENTOPLEX 2 and 3 are multi-purpose greases based on oxidation-resistant mineral oils and lithium soap. They meet the rolling bearing grease requirements according to DIN 51825 K. Due to the good resistance to working under normal temperatures and loads these greases can be used for long-term lubrication. The more viscous CENTOPLEX of NLGI grade 3 is to be used for bearings with inclined or vertical shafts or insufficiently sealed bearings.