Synthetic long-term grease for rolling and plain bearings, linear motion guides
ISOFLEX TOPAS NCA 52 is a synthetic long-term grease with good low-temperature properties. It has a good load-carrying capacity and ensures smooth running even at high speeds and accelerations.
The thickener made of special calcium soap ensures good adhesion to the component and good resistance to media.
The additives contained in ISOFLEX TOPAS NCA 52 increase wear protection.

Fluid gear grease
MICROLUBE GB 00 is a special mineral oil based grease free from solid lubricants. It has a high pressure absorption capacity, provides excellent protection against wear and corrosion, shows good wetting behaviour, water resistance and backflow behaviour.

High-performance gear and multipurpose oil based on mineral oil with KlüberComp Lube Technology
Kluberoil GEM 1 N is a high-performance gear and multipurpose oil based on mineral. Kluberoil GEM 1 N includes KluberComp Lube Technology, i.e. it is based on especially high-grade raw materials and advanced additives, enabling maximum performance in the lubrication of all gear components.
Kluberoil GEM 1 N is approved by Siemens-Flender, SEW, MAAG Gears, etc.

High-performance fluid grease for long-term lubrication
Klubersynth BEM 44-4600 is based on high-viscosity PAO oil and a special lithium soap, which prevents components from leaking due to its thixotropic behavior. Compared to other fluid greases it provides a very good thermal stability due to its synthetic composition thus ensures a longer service life of the lubricant and protects against early wear of the components. It offers good compatibility with other fluid greases based on mineral oil and PAO, thus it helps in a smooth change- over to BEM 44-4600.

Synthetic lubricating grease for the food and pharmaceutical processing industry
Klubersynth UH1 14-1600 is a synthetic high-performance lubricating grease. It is registered as NSF H1 and complies with FDA 21 CFR Sec. 178.3570. It is a contributor towards the supporting of food safety. Its soft consistency, good wear protection and scuffing load stage 11 in the FZG test ensure good lubricant distribution and reduced wear in the gear.

Lubricating oils for slideways and guideways
LAMORA D oils offer excellent lubricity also at low sliding speeds, enabling constant and precise feed motion of workpiece and tool slides. They ensure good wetting of the sliding surfaces and a high load-carrying capacity, especially of slideways with plastic coatings. Tests at SKC Schmidt GmbH & Co. (formerly Hans Schmidt Gleittechnik GmbH & Co.) have shown that the oils attain "good" to "very good" results both in terms of their coefficients of adhesion and their demulsifying behaviour in contact with customary cooling lubricants.
LAMORA D oils are in compliance with ISO 6743 part 13 GA and GB.