White operating and priming lubricants
Kluberplex AG 11- 462 offer very good wear and corrosion protective properties contributing to an efficient operation of your highly loaded installations and components.
These adhesive greases have proven effective for many years, providing reliable protection of components also when exposed to salt water or during extended periods of standstill.

High-temperature lubricating grease
Kluberlub PHB 71-461 is a special high-temperature lubricating grease based on mineral oil and polyurea. It is suitable for a wide service temperature range and can be used up to 180°C under continuous relubrication conditions. Kluberlub PHB 71-461 may be applied via centralized lubrication equipment.
Kluberlub PHB 71-461 incorporates special EP additives ensuring good wear protection under high load conditions.

Operational lubricant for large gear drives
Klubersynth OA 98-15000 is based on the SLIBF concept (Solid Lubricant Integrated Base Fluid) was developed precisely to meet the high demands of open gear drives.
It provides excellent adhesion, good film formation, less splashing from the gears and reducing leakages from the gear casing. This results in better maintenance practices and increased safety. It also provides good pumpability at lower temperatures and offers low resistance to pumping the lubricant.

Synthetic heavy-duty grease for long-term lubrication
Klubersynth HBE 94-401 is a lubricating grease based on high-quality synthetic base oil and a special calcium complex soap thickener. This combination enables the formation of a lubricating film with high resistance to mechanical loads providing excellent wear protection. Moreover, Klubersynth HBE 94-401 is resistant to water and has a good sealing effect due to the special thickener component used.

Synthetic gear and multipurpose oil for the food-processing and pharmaceutical industries
Kluberoil 4 UH1 N is a synthetic high-performance gear and multipurpose oil based on PAO satisfying the growing requirements and increasing power density of modern gears.
These are NSF H1 registered and therefore comply with FDA 21 CFR § 178.3570. The lubricants were developed for incidental contact with products and packaging materials in the food-processing, cosmetics, pharmaceutical or animal feed industries.

Graphite based operational lubricant for open gear drives
Because of its unique chemical composition based on an aluminium soap thickener, the GRAFLOSCON C-SG 0 ULTRA provide good adhesion that protects the tooth flank even at extreme loads.The life of the gear is enhanced by the presence of fine graphite particles that form a protective layer and prevent damage.
The vibrations and temperature difference across the tooth flank are reduced. The gears are also protected against corrosion due to the special additives.